Every furnace call starts with a combustion and carbon monoxide safety check, not just a symptom fix.
Heat exchanger cracks, ignitor failures, and gas valve issues all fall within our scope.
If you're dealing with a pilot light that won't stay lit, an ignitor that clicks but never catches, or a furnace that runs but blows cold air, you already know furnace failures carry a safety dimension — carbon monoxide and gas leaks — that most other HVAC repairs don't, so the diagnostic has to start there.

Most furnace repair problems give some warning before they turn into a pilot light that won't stay lit, an ignitor that clicks but never catches, or a furnace that runs but blows cold air — catching it early usually means a shorter, cheaper fix.
AAA Pro HVAC built its furnace repair process around one idea: diagnose first, quote honestly, fix it right.
Every truck across Austin, IN carries the tools and common parts specific to furnace repair, so most calls finish in a single visit.

Every furnace visit includes a combustion analysis and carbon monoxide test before any repair recommendation.
Our crews are trained on standing pilot, hot surface ignition, and electric resistance furnace systems alike.
No push toward replacement when a repair genuinely solves the problem.
No-heat calls during freeze warnings get moved to the front of the schedule.
Every job starts with a real diagnosis, not a guess — here's the full scope of what our furnace repair technicians handle across Austin, IN.
Hot surface ignitors crack over time and simply stop glowing — we test resistance rather than replacing on assumption. Techs handling ignitor & pilot light repair carry the specific parts and tools this job calls for, not a generic kit.
A gas valve that won't open or won't seal is tested with proper manometer readings, not just listened to. This is one of the most requested furnace repair calls we get across Austin, IN.
A cracked heat exchanger is a carbon monoxide risk and gets flagged immediately with the furnace shut down if needed. This is one of the most requested furnace repair calls we get across Austin, IN.
We test motor amp draw against rated spec before replacement. Techs handling blower motor & limit switch repair carry the specific parts and tools this job calls for, not a generic kit.
We inspect the full flue run, not just the connection at the furnace. This is one of the most requested furnace repair calls we get across Austin, IN.
We test low-voltage circuits before condemning the board. This is one of the most requested furnace repair calls we get across Austin, IN.

Gas odor reports get immediate safety instructions before dispatch details.
Techs arrive with combustion analyzers and common ignitor/gas valve stock loaded.
Safety check first — combustion and carbon monoxide — then full mechanical diagnostics.
Most ignition and control repairs finish same-visit.

Furnace kept clicking like it wanted to light and never catching.
Turned out to be a failed gas valve — they caught it with a proper pressure test, not a guess.
They found a hairline crack in the heat exchanger I never would've noticed.
Thermocouple was the culprit, replaced and tested before the tech left.

A clicking-but-not-lighting pattern is one of the most common furnace complaints we diagnose.
Yes — it's a genuine carbon monoxide risk and we treat it as a safety issue, not a routine repair line.
This symptom shouldn't be ignored since it sometimes points to a safety-related fault.
Electric resistance furnaces fail differently than gas units, and we diagnose accordingly.
Immediately — leave the area and call, don't attempt to diagnose it yourself.
Call dispatch for a live arrival estimate based on current demand.

Our furnace repair crews are positioned throughout Austin, IN to keep response times realistic, not just promised.
☎ Call +1-866-805-8548 for Austin Service